XLifter model X2, user guide, ver. 2.0, firmware ver. 1.07
eXpedition tech s.r.o., Těšnov 5, 110 00 Prague 1, Czech Rep., https//www.xlifter.com, [email protected]
Page 2
1.
Legal disclaimer
You are hereby provided with an air-suspension controller for Land Rover vehicles – product
named XLifter (hereinafter as “
device
” or “
XLifter
”).
XLifter is an additional device able to change/adjust the air-suspension computer/electronic
programming of the vehicle in which the device is installed.
XLifter is not a device approved and designed for installation into vehicles intended to be
operated on public roads namely pursuant to Act. no. 361/2000 Coll, as amended. The
manufacturer does not assume any liability deriving from technical requirements for
operation of vehicles on public roads in case you decide to use this product in traffic on
public roads or anywhere else, where operation of this device may be considered as
unauthorized, whether in the Czech Republic or in any other jurisdiction.
The end-user
assumes all liability connected to use of the device on public roads, derived namely
from the mandatory technical requirements for operation of vehicles on public roads
provided by Act. No. 56/2001 Coll and regulation no. 341/2014 Coll.
By installation of the device the end-user releases/discharges the manufacturer from any
liability connected to any influence or damage (whether financial or immaterial) of the
provided product on other systems, parts or components of the vehicle (whether
mechanical or electronical). By installation of this product the end-user also acknowledges
that this product is meant to be used
in controlled conditions, namely at low speeds and
with increased caution.
The end-user undertakes the responsibility to inform any prospective future owner of the
respective vehicle equipped with the device and/or about installation of the device.
By installation of the device, you acknowledge the above-mentioned and agree with
the above-mentioned terms. Please use the XLifter only in off-road conditions and not
on public roads.
2.
General description
XLifter
is an advanced air-suspension controller for specified Land Rover vehicles. XLifter
allows you to take the air suspension capabilities of your Land Rover to the maximum,
making your off-roading or expedition travelling a greater experience.
XLifter
gives you more detailed control over the vehicle height settings. Raising the vehicle
above the maximum specified (By Land Rover) “Off-road” height, helps you to tackle difficult
terrain. XLifter is not limited by the 40 Km/h speed limit, therefore travelling over long
stripes of sand, green lanes or gravel roads will be more manageable. Also, XLifter keeps
selected lift settings archived, which means that you can keep it as a selected height
constantly should you wish to. Lowering the vehicle, slightly, improves cornering stability
and aerodynamics (which may add to fuel consumption efficiency). Lowering below the
original access height makes it possible for the entering of low-clearance garages or ferries
and makes cargo loading easier.
XLifter’s
unique self-levelling feature makes your in-car or roof top tent conditions more
comfortable during expedition travelling.
XLifter
controls are intuitive and comfortable. The control module with graphical OLED
display and physical buttons is optimized for off-road handling.
XLifter
EAS unit communicates with the control module wirelessly. Installation to your
vehicle is simple and fully removable when required.
No drilling, soldering, or in-car wiring
is required.
XLifter is designed for Land Rover® Discovery 3 (LR3), Discovery 4 (LR4) and Range
Rover® Sport (model L320) vehicles.
Range Rover® L322 2007-2012 support is currently
experimental (in development).
