XLifter model X2, user guide, ver. 2.0, firmware ver. 1.07
eXpedition tech s.r.o., Těšnov 5, 110 00 Prague 1, Czech Rep., https//www.xlifter.com, [email protected]
Page 20
8.
Firmware
●
SW Version
- Shows the firmware version of the control module
and the XLifter EAS unit. If the display shows “WAIT” instead of
the EAS firmware version, wait for a couple of seconds until EAS
unit is connected and retry the function again.
●
Controller update
- Firmware update of the control module. See chapter 8.
●
EAS unit update
- Firmware update of the EAS unit.
●
Serial numbers
- shows the serial numbers of both EAS unit and control module.
●
Comm Firmware
- shows identification of the BT modules firmware.
9.
Clear calibration
●
Deletes the XLifter calibration. XLifter will display “!NOT! CALIBRATED” and will need
to be calibrated again.
●
Useful when moving XLifter to another vehicle or selling it. Please do not let new
user use the XLifter with wrong calibration!
10.
Debug
[ON]/[OFF]
●
Displays the voltage values on each wheel height sensors instead of the shock
absorbers infographics plus additional diagnostic information.
●
Default setting is OFF, no need to switch on.
8.
Firmware update
The control module uses built-in WiFi for firmware updates. New binary file, containing
microcode for both control module and the EAS unit, is simply uploaded into the control
module from any web browser. The Control module subsequently updates the XLifter EAS
unit.
If the control module detects new EAS unit firmware upon power-up, upgrade is offered.
EAS update can be also started manually from the Service menu.
Control module update procedure:
1.
Download a new version of the firmware into your mobile phone or notebook.
●
Save the file for example to “My Files” or “Downloads” folder in your mobile. On the
iPhone, do not save file to iCloud Drive, save/move it to “On My iPhone” instead!
●
The file must be saved into an internal storage because your mobile does not have
an Internet access throughout the update procedure.
2.
Enter the Service menu, choose “
Firmware
”
and then choose
“
Controller updt
” by pressing
.
●
The control module creates a local WiFi network called
“XLifterC”. The password is shown on the display (second line, after p: )
3.
Connect your mobile to the “XLifterC” WiFi network.
●
Mobile can indicate that the “XLifterC” network does not provide internet access,
which is okay, keep the XLifterC WiFi connected.
●
For newer mobiles you might need to turn off the smart WiFi switch, otherwise it
might disconnect from WiFi that does not provide internet access.
4.
In mobile phone or notebook that has been connected to the “XLifterC” WiFi network
open a web browser and type the “
192.168.4.1/update”
into the web page address box.
