XLifter model X2, user guide, ver. 2.0, firmware ver. 1.07
eXpedition tech s.r.o., Těšnov 5, 110 00 Prague 1, Czech Rep., https//www.xlifter.com, [email protected]
Page 19
7.2.
Service menu items description
1.
Keylock [ACTIVE! / inactive]
●
Activation/deactivation of the key lock. Locked keys can only be
unlocked with this Service menu item.
2.
Pair EAS unit
●
Wireless pairing of the control module and the XLifter EAS unit.
●
The control module and the XLifter EAS unit are paired before shipping. Use this
function when you need to pair new unit due to replacement.
●
After activation, the control module scans available Bluetooth devices and offers
them for pairing. The name of the XLifter EAS unit is "XLIFTER EAS". Do not pair the
control module to any other devices.
3.
Car type
●
Sets various internal parameters according to a vehicle type.
●
Since firmware 1.00, this menu is also accessible via the
Calibration user menu.
●
Refer to the chapter 4.5 Vehicle type and calibration settings for
vehicle type specifics.
●
After setting the car type, you will be required to run calibration again.
4.
Steering position
●
The XLifter EAS unit mounting position depends on steering
wheel side and the tilt sensor behaviour must be adjusted.
●
Set accordingly to your vehicle.
●
Since firmware 1.00, this menu is also accessible via the
Calibration user menu – refer to chapter 4.5.
5.
Default lift (+xx)
●
Sets default lift from -15mm to +55mm into which Xlifter “boot
up” after reset (battery disconnection, controller disconnected
for a long time).
●
Designed for 32” and bigger tires users – Xlifter will act as true
mechanical lift rods replacement.
6.
Corners adjustment
●
Feature allows offseting each wheel independently by +-20mm.
●
Helps to compensate poorly calibrated vehilcle (Land Rover
heigh calibration).
●
Inteded as a tempotary fix only
– have you vehicle calibrated
ASAP by proper diagnostic tool.
Do not use this feature if you
don’t need to.
●
If any wheel if off-set, small up or down arrow is shown in shock-
absorbers infographics on home screen (as a reminder to fix LR
calibration!).
●
Using this feature does not extend total available lift!
7.
AppWiFi
[Always On] | [Normal]
●
Leave on [Normal] unless required!
Feature increases
Controller’s power consumption and it may heat up slightly.
●
Keeps WiFi access point for mobile application always on.
Special feature intended for cars with custom built-in mobile
tablets or similar displays.
●
Always set to [Normal] before firmware upgrade
