XLifter model X2, user guide, ver. 2.0, firmware ver. 1.07
eXpedition tech s.r.o., Těšnov 5, 110 00 Prague 1, Czech Rep., https//www.xlifter.com, [email protected]
Page 6
3.
Disconnect wiring harnesses from the original LANDROVER EAS unit
The Land Rover EAS unit is located at the left
(right for RHD vehicles) inner side of car
body – approx. in the middle of imaginary
line between the end of A pillar and drivers
footrest.
Use a flashlight to illuminate the work area.
a.
Disconnect the A and B connectors.
Disconnect the connector by pushing the connector lock and pulling it
outwardly. The A and B connectors are the most left and right ones.
b.
Place the disconnected cable harnesses temporarily behind the rest of the cables
in area. This will help you to create enough space for a comfortable XLifter EAS
unit installation.
4.
Install the XLifter EAS unit
Prior to sticking the XLifter EAS unit into its final position, it may be a good idea to
practice placing the EAS unit, without having removed the 3M reclosable fastener
protective foil. The 3M fastener sticks very firmly once placed in a position making it
difficult to remove or move.
The XLifter EAS unit is equipped with a tilt sensor. The unit must be positioned upright
and as accurately – in approximate to the vehicle’s level position on the level surface – as
possible. Otherwise (sticking it horizontally or "upside down"), the leveling function will
not work properly.
a.
On the unprinted side of the EAS unit, remove the adhesive protection foil from the
3M fasteners.
b.
Place and stick the XLifter EAS unit to
the original Land Rover EAS unit as
shown.
●
The printed side of the unit faces the
centre tunnel.
●
The arrow marked THIS SIDE UP is
pointing up.
●
For the sticking itself, it takes a few
seconds with strong force required.
