XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98
Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, [email protected]
Page 8
8.
Re-install the lower dashboard cover panel
●
Re-install the cover in reverse manner when dismantling it (just follow the
instructions from step 2 in a reverse order).
●
Do not forget to connect the light connector.
●
When installing the cover back, it is necessary to "hit" with three centreing
protrusions on the rear of the cover to the holes on the wall behind the steering
pedals.
●
The cover needs to be slightly bent again, it is better to first install the part on the
side of the EAS unit and then the side at the centre tunnel.
4.4.
Control Module Installation
The control module and the EAS unit communicates wirelessly, therefore choosing a
suitable location is freely at your will.
The control module is powered from ignition-sw12V power supply (e.g. cigarette
lighter socket etc.). If you have enough skills and wish to do so, you can cut off this
connector and hard-wire it into another suitable 12V source later (e.g. cigarette socked
wiring behind centre dashboard), thus making the wiring invisible. The power cable has
standard colours – red for + pole and black is – pole. The control module is equipped with
reverse-polarity protection circuit.
Control module installation procedure:
1.
Connect the control module power
Plug the 12 V power plug into the cigarette lighter socket.
Attach the control module with the supplied installation material (Velcro) or at
your own discretion to a suitable location (or do this later).
2.
Quick-check the control module
●
Turn the ignition ON
●
The animated logo and the scrolling XLifter EAS unit wireless search indicator
appears on the control module display.
●
The control module and the XLifter EAS unit were already paired for you. The
communication should be established within max. 10 seconds. Please allow up to
20 seconds if the EAS unit was just powered up by connecting the C connector, or
by connecting the vehicle battery.
●
When communication is established, the XLifter "home
screen" appears. It will show zero lift and "Not Calibrated" info.
