XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98
Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, [email protected]
Page 9
4.5.
Vehicle type and calibration settings
Before using the XLifter for the first time, it is necessary to set the type of your vehicle and
run the calibration procedure.
1.
Enter the service menu.
The control module displays the service menu if any button is
held pressed when the control module power is turned on.
a)
Pull the control module's 12V plug from the cigarette lighter
socket (the control module display turns off).
b)
Press and hold down any control module button
and reinsert the power
plug. The control module displays the service menu. Then release button.
In case of any troubles with entering the service menu, or in case the Control module
has been „hardwired“ to a +12V supply, please read the chapter 7.1 Entering the
Service menu. The procedure is described there with more details and options.
2.
Use the buttons
and
to select "Car Type" and
set the
corresponding vehicle type
. Then press
to return to the
service menu.
3.
If you have a right-hand drive vehicle, invoke "
Steering position
"
and set "RIGHT HAND". Then press
to return to the service
menu.
4.
Press
to quit the service menu.
5.
Calibrate the XLifter (see chapter 6 Calibration for details).
From home screen, press
to enter to the XLifter
main menu
,
select „Settings” and press
, then select „Calibration“.
Congratulations! The installation is finished.
4.6.
Dismantling XLifter from vehicle
Of course, XLifter can be dismantled from the vehicle. The procedure is the opposite of the
installation, with the following differences:
●
In case of temporary disassembly, you may leave the XLifter cable harness still
installed. In such case, you only disconnect the connector C from the XLifter EAS
unit (see the manual for installation, point 5c, chapter 4) and then plug the bypass
connector into disconnected C connector.
●
The EAS unit is detached from the 3M reclosable fastener by a strong pull
perpendicular to the printed side (direction to the centre console). You cannot
separate the fastener by pulling the EAS unit to either side. Do not remove the
fastener left stuck on the original EAS unit. It holds very well. For reassembly into
another vehicle, use a new piece of fastener (not supplied). It is a 3M SJ3550 3M
reclosable fastener, 25 mm wide, 39 head per cm2.
