XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98
Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, [email protected]
Page 6
3.
Disconnect wiring harnesses from the original LANDROVER EAS unit
The Land Rover EAS unit is located at the left
(right for RHD vehicles) inner side of car
body – approx. in the middle of imaginary
line between the end of A pillar and drivers
footrest.
Use a flashlight to illuminate the work area.
a.
Disconnect the A and B connectors.
Disconnect the connector by pushing the connector lock and pulling it
outwardly (with some light wobbling). The A and B connectors are the most left
and right ones.
b.
Place the disconnected cable harnesses temporarily behind the rest of the cables
in area. This will help you to create enough space for a comfortable XLifter EAS
unit installation.
4.
Install the XLifter EAS unit
Prior to sticking the XLifter EAS unit into its final position, it may be a good idea to
practice placing the EAS unit to a correct position for a few times, without having
removed the 3M reclosable fastener protective foil. The 3M fastener sticks very firmly
once placed in a position and makes it very uneasy to replace it once stuck in a place.
The XLifter EAS unit is equipped with a tilt sensor. The unit must be positioned at least
approximately according to the procedure described. Otherwise (sticking it horizontally
or "upside down"), the leveling function will not work properly.
a.
On the unprinted side of the EAS
unit, remove the adhesive protection
foil from the 3M fasteners.
b.
Place and stick the XLifter EAS unit
to the original Land Rover EAS unit
as shown.
●
The printed side of the unit faces the
centre tunnel.
●
The arrow marked THIS SIDE UP is
pointing up.
●
For the sticking itself, it takes a few
seconds with strong force required.
