XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98
Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, [email protected]
Page 7
5.
Connect the XLifter cable harness
a.
Connect the connectors A(out) and B(out)
of the supplied cable harness to the original
Land Rover EAS unit.
b.
Plug the previously disconnected
connectors to the connectors A(in) and
B(in) of the supplied cable harness.
c.
Plug the connector C to the XLifter EAS
unit.
NOTICE:
Place the "loose" cables in a way so they do
not move freely. If necessary, use any
tightening strap (not included). This
prevents them from "knocking out" in long-
term operation.
None of the connectors are
interchangeable. You cannot connect the
cable harnesses in a wrong way.
All connectors must be fully inserted as
far as they will go, as shown. Some
connectors, especially B ones, require
slightly more force to fully connect.
Incomplete insertion is the source of unpredictable problems, please pay
attention here!
6.
Connect the vehicle battery in accordance with the vehicle user manual
●
Only if you disconnected it in step 1.
●
Discovery 4: The “Suspension error” will be displayed.
Cycle the ignition to clear it
.
●
Discovery 3: The “Suspension error” should clear itself in few seconds.
7.
Check the status LED on the XLifter EAS unit
●
The green status LED flashes at a fast pace - 2x per second, indicating readiness for
operation and awaiting wireless connection from the control module.
