Xerox WorkCentre 3215, Service Manual

Page: 29 / 186

June 2014
2-7 Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
06-100 / 200 , 07-110
Status Indicator RAPs
Y N
Check that there is no contamination present. Replace the Harness (REP1.11)
[PL4.1]
Replace the Laser Module.( REP 1.11 ), PL 4.1 .
Go to SCP 04 Final Actions.
07-110 Paper Tray 1 Empty Fault
The Tray Empty Sensor failed to detect paper in the tray.
BSD-Reference: 7.1 Paper Feed and Registration
Initial Actions
Ensure that paper is loaded in the tray. Clear any jammed sheets. Refer to Section 11 in the
WorkCentre 3215/3225 User Guide for detailed instructions on clearning paper jams.
Procedure
Check the Paper Tray Empty Sensor actuator. The actuator moves freely and is undam-
aged.
Y
N
Replace the Paper Tray Empty Sensor actuator
PL 4.5 .
Enter Diagnostic Mode. Select: [Machine Test, EDC Mode, DC330 Component Control, 102
Sensor, Tray 1 Empty] to block and clear the Tray 1 Empty Sensor. The sensor signal
changes.
Y
N
Check for 3.3VDC on the Main PWB PWB. The voltage is present on the Main PWB.
Y
N
Check that all voltages are present between the HVPS PWB and the Main PWB.
The voltages between the HVPS PWB and the Main PWB are present
Y
N
•
Replace the HVPS PWB ( REP 1.6 ), PL 4.1 .
• Replace the Main PWB ( REP 1.8 ), PL 4.1 .
Replace the Paper Tray Empty Sensor PL 4.5 .
Replace the Paper Tray Empty Sensor PL 4.5 .
If the problem is intermittent, check the circuit of the Tray Empty Sensor.
A