User Safety
Phaser® 6180MFP Multifunction Printer
1-4
Maintenance Safety
■
Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
■
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
■
Do not attempt to open, reuse, or burn any consumables or routine maintenance items. For
information on Xerox supplies recycling programs, go to
www.xerox.com/gwa
.
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.Your attention to the following safety guidelines helps to ensure the continued, safe
operation of your printer.
Printer Location
Place the printer in a dust-free area within a temperature range of 50° F to 95° F (10° C to
35° C) and a relative humidity range of 15 percent to 80 percent.
Note:
Sudden temperature fluctuations can affect print quality. Rapid heating of a cold room
can cause condensation inside the machine, directly interfering with image transfer.
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
■
35 cm (13.8 in.) above the printer
Total Height Requirements:
■
108 cm (42.5 in.)
Other Clearances:
■
10 cm (3.9 in.) behind the printer
■
60 cm (23.6 in.) in front of the printer
■
10 cm (3.9 in.) on the left side of the printer
■
10 cm (3.9 in.) on the right side of the printer