Control Panel Error Messages
Phaser® 6180MFP Multifunction Printer
10-34
Messages About the Printer and Other Items
Message
Condition/Reason/Action
042-700
Over Heat
The printer’s internal temperature is too high.
The printer has been stopped. Wait 1 hour before restarting the
printer. Ensure the printer has adequate cooling space around it,
and that the cooling vents are not blocked.
077-912
Push in Tray 2
Tray 2 is pulled out.
Push Tray 2 into the correct position.
Controller Error
Error 116-397
and
-398
Restart Printer
An internal controller error occurred.
Restart the printer.
Disabled Func
Press OK
The function that you are trying to access has been disabled.
Enable the function through the control panel menus, or contact
your printer administrator. See
Using the Control Panel Menus
and Keypad
on page 9-1.
Door A Open
Close Door A
The front cover is open.
Close the front cover.
Fan Motor Error
Error 042-3NN
Restart Printer
An error has occurred with the fan.
Restart the printer. If the problem persists, contact Xerox
Technical Support.
Fuser Error
Error 010-397
Error Code: xx
Restart Printer
A fuser error has occurred.
Restart the printer. If the problem persists, contact Xerox
Technical Support.
Invalid Feature
Press OK
The user is not registered to print in color when using an
authentication function.
Contact your administrator.
Invalid Job
Press OK
When the configuration of the printer on the print driver does not
conform to the printer you are using, this message appears.
Press the
Stop
button to cancel the print job.
Make sure that the configuration of the printer on the print driver
conforms to the printer you are using.
Invalid User
Press OK
The user is not registered to print on the printer when using an
authentication function.
Contact the administrator.
Jam at Tray 1
Check Tray 1
Open Door A
Paper is jammed inside Tray 1 (MPT).
Remove the jammed paper. Open and close the front cover. See
Paper Jams
on page 10-2.
