Xerox DocuPrint 4850 NPS, Configuration Manual

Page: 21 / 276

XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM xi
Introduction
This Xerox DocuPrint Network Printer Series Guide to Configuring
and Managing the System provides information on how to perform
system administration tasks for the DocuPrint NPS.
About this guide
This guide is intended for system administrators who are responsible
for setting up and maintaining DocuPrint NPS printers.
Users should have an understanding of Printer Controller operations
and, for some tasks, be familiar with basic UNIX commands.
Some of the procedures described in this guide may be performed by
the printer operator. For more information on printer operator tasks,
refer to
Xerox DocuPrint Network Printer Series Guide to Managing
Print Jobs and the other documents in the Xerox DocuPrint Network
Printer Series.
Before using this guide, become familiar with its contents and
conventions.
Contents
This section lists the contents of this guide:
•
Chapter 1, “Using the system interface,” describes how to
access the system at the administrator and operator levels and
outlines how to enter commands at the Printer Controller.
•
Chapter 2, “Using utility commands,” describes the use of a
number of utilities such as backup and restore site files,
Configure, and other useful commands.
•
Chapter 3, “Starting and stopping the system,” describes how
to power on and off the system, and how to start and stop job
processing, the sequencer, and the system.
•
Chapter 4, “DocuPrint NPS on a Novell network,” contains a
brief overview of Novell NetWare, and describes some of the
things you must consider before the service representative
installs DocuPrint NPS on a Novell network.
•
Chapter 5, “Setting system defaults,” provides information on
how to set system defaults.
•
Chapter 6, “Input and Output profiles,” describes commands
used for DocuPrint NPS configured with third party input and
output devices.
•
Chapter 7, “Setting the Printer Controller date and time,”
describes how to set the time on the Printer Controller.