Xerox DocuPrint 4850 NPS, Configuration Manual

Page: 171 / 276

INPUT AND OUTPUT PROFILES
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 6-3
Profile parameters
Create, then set Profile parameters for optional input and output
devices as required using the following setoutputdevice parameters.
Set output device parameters for optional output devices. Typically,
all values are zero except those for p7, p10, p11, and p12.
Parameters <name>
The name (usually 6–8 characters) you assign to the device
Profile.
<p1>
Specifies the minimum time that the printer waits between
sheets when delivering them out of the bypass transport.
Acceptable values range from 0 to 65535 ms.
<p2>
Specifies the acceptable time interval between the SHEET EXIT
signal and SHEET DELIVERED signal. Acceptable values
range from 0 to 12999 ms. (See also <p7>.)
<p3a>
Specifies the time between sending last page of one set and first
page of next set. Acceptable values range from 0 to 65535 ms.
<p3b>
Specifies the minimum time between two consecutive ends of
sets.
<p4>
Specifies the maximum time between the printer sending an
END OF SET signal and the output device responding with a
SET DELIVERED signal. Acceptable values range from 0 to
12999 ms.
<p5>
Specifies the time between the printer sending a CYCLE UP
signal and the output device being ready to accept sheets.
Acceptable values range from 0 to 65535 ms.
<p6>
Specifies the mode of operation for the DFA device:
0=automatic
1=Finishing Funtion 1 ALWAYS
2=Finishing Funtion 1 NEVER
4=Finishing Funtion 2 ALWAYS
8=Finishing Funtion 2 NEVER
4096=always recover to sheet boundaries for failures involving
the DFA device
8192=always recover to set boundaries for failures involving the
DFA device
16384=auto restart after DFA full (not currently implemented)
32768=1-N (face-down) output—If you use a DFA connected
finishing device on a Model 96, 4635, or 180, and you wish to
specify 1-N output, add 32768 to the P6 value, and enter the
sum of the two numbers.