Xerox DocuPrint 4850 NPS, Configuration Manual

Page: 123 / 276

SETTING SYSTEM DEFAULTS
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 5-19
Change Imager Parameters
Use the Change Imager Parameters command to change the values
of the imager parameters for PostScript and ASCII only.
Access level Administrator
Syntax Change Imager Parameters
Arguments None. The system prompts you for the value of each parameter as
follows:
LineThicken
Indicates the amount in pixels of thickening you want applied to
the lines in a print job. The value for this parameter must be
between 0.0 and 100.0.
Recommended values for darkening levels are as follows:
•
Slight darkening 1.0
•
Medium darkening 2.0
•
Heavy darkening 3.5
Note: Specifying the 3.5 value for heavy darkening has
approximately the same effect as using the thicken
document attribute.
FontThicken
Indicates the amount in pixels of thickening you want applied to
the strokes within a font for PostScript and ASCII only. The value
for this parameter must be between 0.0 and 100.0.
If you change the FontThicken parameter, examine the output
carefully to ensure that the thickening level, as well as the overall
image quality, is acceptable. Depending on the font and printer
you are using, changing the FontThicken parameter may cause
some characters to appear distorted.
Recommended values for darkening levels are as follows:
•
Slight darkening 2.0
•
Medium darkening 5.0
•
Heavy darkening 7.0
Note: Specifying the 7.0 value for heavy darkening has
approximately the same effect as using the thicken document
attribute.