Xerox document centre 235 series, User Manual

Page: 39 / 209

S
e
tting Up
27
2
2.5
Setting IP Address
This section explains how to set the IP address.
Depending on the network environment, you may need to set the subnet mask and gateway address.
If your network has a Dynamic Host Configuration Protocol (DHCP), BOOTP or RARP environment,
the printer can obtain these items automatically from each of the server.
By the factory setting, these items are obtained automatically from the DHCP server.
● Use the DHCP server together with the Windows Internet Name Service (WINS) server at the same time.
When using the WINS server, set settings if necessary, by selecting the following on the printer control panel:
Network/Port, followed by WINS Server, and then the various items.
●
When using the BOOTP or RARP server, select the following on the printer control panel:
Network/Port, followed by TCP/IP Settings, Get IP Address, and then BOOTP or RARP.
Check with your system administrator if you have any queries on the BOOTP or RARP environment.
"5.3 Common Menu Items" for details on each of these items and the way to set them.
2.5.1 Flow of setting
When the IP address is obtained automatically from the DHCP, BOOTP or RARP server, you
do not need to follow the procedure in this section to set the IP address.
When you need to set the IP address manually using the printer control panel, refer to "2.5.2
Setting Address".
When you are unsure whether you have a DHCP server, follow the procedure below to check.
If you do not have a DHCP server, set the IP address by referring to "2.5.2 Setting Address".
Checking DHCP server
Check with your system administrator if you have any queries on DHCP environment.