Xerox document centre 235 series, User Manual

Page: 132 / 209

5.3 Common Menu Items
120
Mode
M
e
nu and Common Menu
5
FTP Client The following items are to be set when using FTP Client.
Port Status
Sets the port status of the FTP Client port when the power is switched on. The
candidate values are:
• Enable
• Disable (default)
If the memory is not enough when the Port Status is set to Enable, it may be set to
Disable automatically. When this happens, either set the Port Status of other ports not
in use to Disable or change the memory allocation.
SNMP The following items are to be set when using SNMP. These SNMP settings are
necessary when using an application program to manage multiple printers
remotely. The printer information is managed by SNMP and gathered from
SNMP by the application program.
Port Status
Sets the port status of the SNMP port when the power is switched on. The
candidate values are:
• Enable (default)
• Disable
If the memory is not enough when the Port Status is set to Enable, it may be set to
Disable automatically. When this happens, either set the Port Status of other ports not
in use to Disable or change the memory allocation.
Transpt Protocol
Sets the protocol of the transport layer used by SNMP. The candidate values
are:
• UDP (default)
• IPX
•
IPX, UDP
●
To use UDP, you will need to set the IP address on both the computer and printer.
●
Refer to the manuals of the application program to decide whether to use IPX or
UDP.
Community (R)
Registers the community name needed to read the printer management
information (MIB). Enter up to 12 characters for the name. Default is Not
Registered.
Community (R/W)
Registers the community name needed to read/write the printer management
information (MIB). Enter up to 12 characters for the name. Default is Not
Registered.
Community (Trap)
Registers the community name used by the trap. Enter up to 12 characters for
the name. Default is Not Registered.
Menu item Explanation