DocuColor 5252 System Administration Guide
2-66
Tools Mode
Decurler Setup
Use the Decurler Setup feature to compensate for paper curl in
your prints.
Paper curl is caused by many variables:
•
The manufacturer’s brand of paper and the manufacturing lot.
•
The weight of the paper, and if it is coated or uncoated.
•
The amount of dry ink/toner and the area being covered on a
sheet. The heavier the coverage, the greater the tendency to
curl.
•
The atmospheric conditions of the room where the paper is
stored.
•
The atmospheric conditions of the room where the digital
press with scanner is located.
•
The heat generated during the fusing processes.
The digital press is equipped with an automatic curl control system
that uses the variables listed above to determine the amount of
pressure needed at different Decurlers to reduce the curl.
Key point:
If you notice that output prints have too much curl,
first try flipping over the stack of paper in the paper tray being
used. You can also try running the job from a different tray. If curl is
still a problem, refer to the tables below for your market area to
change the default Decurler settings.
Summary of Contents for DocuColor 5252
