Xerox B205, Service Manual

Page: 26 / 206

July 2019
2-5 Xerox® B205/B215 Multifunction Printer Service Manual
03-900 , 04-500
Status Indicator RAPs Initial Release
03-900 Main PWB Motor Control Chip RAP
BSD-ON: BSD 1
Control Panel Fault Displayed
B205: UI Error
B215: Communication Error
The Motor Control Chip on the Main PWB is not functioning normally.
Procedure
1. Switch off, then switch on the machine
2. The fault persists, install a new Main PWB, PL 1.1 Item 4 .
04-500 Drive Motor Start RAP
BSD-ON: BSD 1
Control Panel Fault Displayed
B205: Motor error turn off then on
B215: Device Error
The front door is open or the Front Cover Latched Sensor is defective.
The Main Drive (BLDC) Motor did not start within the specified time after the ready signal was
sent.
Initial Actions
• Switch off, then switch on the machine.
WARNING
Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power
is on or electrical power is supplied.
DANGER: Ne pas effectuer de dépannage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine: celle-ci pourrait démarrer et causer de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con la macchina accesa o con l'ali-
mentazione elettrica inserita. La macchina potrebbe avviarsi all'improvviso e causare
gravi ferite.
VORSICHT: Es dürfen keine Reparaturarbeiten durchgeführt werden, solange das Gerät
eingeschalten oder mit der Stromquelle verbunden ist. Das Gerät kann u.U in den Aktiv-
Zustand übergehen und somit erhebliche körperliche Schäden verursachen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente.
La máquina podría activarse y ocasionar daños personales graves.
Procedure
Enter Diagnostic Mode, GP 1 , [DC330, [100] Main BLDC Motor] to start the motor. The
motor rotates.
Y
N
Remove the Right Cover REP 2.2 , then check the motor connector on the Main PWB.
The connector on the Main PWB is connected correctly.
Y
N
• Check that there is no contamination present
• Check for broken and defective wires or cables.
• Securely reconnect the motor connector.
Manually rotate the Main Drive Unit, PL 4.6 Item 18 . The Main Drive Motor rotates
freely.
Y
N
Install a new Main Drive Unit, PL 4.6 Item 18 .
The Main PWB is defective.
• Install a new Main PWB, PL 1.1 Item 4 .
A