July 2019
2-10
Xerox® B205/B215 Multifunction Printer Service Manual
07-110, 07-130
Initial Release
Status Indicator RAPs
Install a new Exit Sensor,
PL 4.5 Item 3
.
If the problem is intermittent, check the circuit of the Exit Sensor.
07-130 Paper Jam in Tray 1 RAP
BSD-ON:
BSD 1
Control Panel Fault Displayed
B205: Paper Jam in Tray1
B215: Jam in Tray 1
A paper jam has occurred in Tray 1.
Initial Actions
•
Remove jammed paper from Tray 1 area. (Refer to Section 11 in the Xerox® B215/B205
User Guide for detailed instructions on jam clearance.)
•
Clear the paper path of any debris or obstructions.
•
Ensure the loaded paper is within machine specifications. Refer to Section 6 General Pro-
cedures for product specifications.
WARNING
Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power
is on or electrical power is supplied.
DANGER: Ne pas effectuer de dépannage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine: celle-ci pourrait démarrer et causer de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con la macchina accesa o con l'ali-
mentazione elettrica inserita. La macchina potrebbe avviarsi all'improvviso e causare
gravi ferite.
VORSICHT: Es dürfen keine Reparaturarbeiten durchgeführt werden, solange das Gerät
eingeschalten oder mit der Stromquelle verbunden ist. Das Gerät kann u.U in den Aktiv-
Zustand übergehen und somit erhebliche körperliche Schäden verursachen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente.
La máquina podría activarse y ocasionar daños personales graves.
Procedure
Remove Tray 1 and ensure that guides are set correctly.
The paper is loaded correctly in the
tray.
Y
N
Align the paper in Tray 1 then reinsert the tray.
Check the position of the jammed sheet.
The lead edge reached the Retard Roll.
Y
N
Enter Diagnostic Mode,
GP 1
,
[Machine Test, Diagnostics Mode, DC330, [102] Feed
Sens]
to block and clear the Feed Sensor.
The sensor signal changes.
Y
N
Check for 3.3VDC on the Feed Sensor PWB.
The voltage is present at the con-
nector on the Feed Sensor PWB.
Y
N
Check for 3.3VDC on the Main PWB.
The voltage is present on the Main
PWB.
A
B
A
B
C
Summary of Contents for B205
