Installation and Setup
2-7
Front panel (P12), Rear Transition Module and Vita 31.1 Ethernet
____________________________________________________________
The Ethernet ports on the XVME 689-VR7 are switch able between the front and the rear of the XVME 689-
VR7. When in the rear mode, the Ethernet ports can use the (optional, available at order time only) PO
connector for either Vita 31.1 switch fabric over the Vita 31.1 compliant backplane or Ethernet out the XVME
990-VR7/2 rear transition module. The Vita 31.1 and the rear transition module can not supply Ethernet at the
same time, if a Vita 31.1 compliant backplane is in use then the rear transition module RJ-45s must not be
used.
Table 2-8 RJ-45 10/100/1000 BaseT Connector Pin out
Figure 2-8 RJ-45 10/100/1000Mbps
Pin
Signal
1
TX+
2
TX-
3
RX+
4
GND
5
GND
6
RX-
7
GND
8
GND
Summary of Contents for XVME-689-VR7
Page 4: ......
