Xantrex XW4024 230 50, Installation Manual, Page: 38 / 68

Inverter/Charger Installation
2–20 975-0384-01-02
This manual for use by qualified personnel only
Accessing the AC Terminal Block and AC Ground Bar
The AC terminal block includes two terminals each (L and Neutral) for AC Grid
input, AC Generator input, and AC Load connections. The neutrals are
connected to each other, requiring only one neutral connection when the
installation uses a Xantrex XW Power Distribution Panel. Without the Xantrex XW
Power Distribution Panel, additional neutral connections may be required at the
input sources.
The AC terminal block is located on the left side of the inverter beneath the AC
access cover. See Figure 2-12.
Figure 2-12 AC Terminal Block and Ground Bar
Hybrid Inverter /Charger
Gri d (AC1)
Gen (AC2)
Faul t /
Warni ng
Equal i ze Battery
Chargi ng
Inverti ng
Flashing = sell
AC
LOAD
GRID
(AC1)
GEN
(AC2)
AC
OUT
AC IN AC IN
L
N
L N
L
N
When replacing the AC
access cover, make sure its
recessed edge slips inside
the edge of the front panel.
Recessed
edge
Remove the two screws on
the AC access cover and
slide it to the left of the
inverter to remove it.
AC Terminals
AC Ground Bar