XAG AUSTRALIA
114
Pre-Flight Checklist
01
Inspect and ensure the integrity of the Airframe. (Only use genuine parts in good
condition)
02
Inspect and ensure the propellers are Clean and in good condition (DO NOT use aged,
chipped, damaged or stained propellers), and the correct Propeller are installed on each
Arm.
Arm 2 & 4 – CCW Propeller
Arm 1 & 3– CW Propeller
03
Inspect and ensure there are no foreign objects inside of the aircraft or its components,
such as water, oil, soil, or sand.
04
Inspect and ensure the batteries, liquid tank, and the Motor is properly secured.
05
Check & ensure Firmware & APP is up-to-date.
06
Check and ensure there are sufficient battery for the operation (Including Aircraft
Batteries, LNT, Remote Controller and RTK Station Battery).
07
Check and ensure all aircraft are paired with Remote Controller, and ready to operate
the aircraft and manually avoid obstacles promptly or during an emergency.
08
Check and ensure the Communication is Normal
√
RPA enters RTK Mode
√
RPA Heading Accuracy < 2º
√
Number of Satellites > 16
09
Check and ensure the Dynamic Radar, PSL Camera and Terrain Sensor are Clean and in
good Condition (Not cracked, chipped, sunken, misshapen, or obstructed).
10
Perform System Calibration of RevoSpray / RevoCast System.
11
Perform Motor Test to ensure it is operating normally (Idle Test & In-Situ Flight Test).
