13
®
LEADERS IN POLE & AERIAL FITNESS
Copyright© Vertical Leisure Ltd. 2020 Version 3.0
All rights reserved.
Pole Retaining
Screw (M8)
Pole Retaining Screw (M8)
Push Down
4mm Hex Key
More than
3mm Gap
Bearing Retaining Screw
(M10) Domed
1-2mm Gap
5mm Hex
Key
Bearing Retaining Screw
(M10) Domed
Fig. (11.6)
Fig. (11.7)
Make sure the bearing unit is firmly seated into the bearing carrier (Fig.11.6). Tighten the Bearing Retaining screws (3 x
M10 Domed Screws) firmly using the 5mm Hex Key – ensure that your bearing unit is tightened into the bearing carrier.
Tighten progressively – first lightly tighten each screw – then re-tighten all three firmly. (Replacement screws can be
purchased from your local X-Pole agent).
‘A’ Pole
Bearing Unit
Static & Spin Screw (must be
in static mode to remove pole)
X
5mm Hex Key
Fig. (11.8)
Fig. (11.9)
Next, ensuring the pole is seated properly in the bearing
of the Main Stage Frame base, push firmly down on the
pole. Secure the 'A' POLE in place by tightening the 3 x
M8 (Pole retaining screws using the 4mm Hex Key)
in the cone section of the bearing unit.
IMPORTANT:
When dismantling, leave the complete
bearing unit attached to your 'A' POLE. It is critical to
tighten the 2 x Static/Spin hex screws and set your pole
to 'STATIC' mode prior to removal.
If the bearing unit
is in spinning mode, the pole cannot be removed.
TIP: Prior to every use, make sure the screws are tight.
Not Seated
Seated