XDS PRO4-P Receiver User‟s Guide
X-Digital Systems
Rev K - July 29, 2008
30
3.4
Console Commands
Tasks are performed through the console via commands. The syntax for any command is
the name of the command, followed by a comma separated list of one or more option
command arguments. Below is a list of available commands along with the arguments for
each command and the action of the command.
3.4.1 The ALARM Command
The ALARM command tells you, and allows you to change, the current ALARM mask
the receiver is using. To see the current ALARM mask without modifying it, simply type
ALARM without an argument following it. To change the alarm mask, type: ALARM
<MASK>, where <MASK> is a hexadecimal digit in the range [0-FFFFFFFF]. Anything
larger than FFFFFFFF will be interpreted as the largest mask, FFFFFFFF.
The ALARM command is only available to the tech profile.
3.4.2 The E0 and E1 Commands
The E0 and E1 commands change various settings for the first and second Ethernet ports
respectively. The command followed by any of the below options will display that
parameter if there is no argument given, or change that parameter to the argument if an
argument is given.
Option
Argument
Action
SHOW
Shows various technical data regarding the specified
interface
MAC
Same as the SHOW option.
DHCP [ON/OFF]
Sets DHCP to ON or OFF depending on the argument.
ADDR [a.b.c.d]
Sets the Ethernet port‟s address to argument. Run
without an IP address argument will display the current
address.
MASK [a.b.c.d]
Sets the Ethernet port‟s subnet mask to the argument.
Run without a subnet mask argument will display the
current subnet mask
GATEWAY [a.b.c.d]
Sets the Ethernet port‟s gateway to the argument. Run
without a gateway address argument will display the
current gateway.
DNS [a.b.c.d],[e.f.g.h],…
Sets the Ethernet port‟s DNS servers. One to four DNS
servers can be specified in a coma delimited list. Run
without a DNS server argument will display the current
DNS servers
