21
Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and
other European countries with separate collection systems)
This symbol on the product or on its packaging indicates that this product shall
not be treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling of
this product. The recycling of materials will help to conserve natural resources.
For more detailed information about recycling of this product, please contact
your local city office, your household waste disposal service or the shop
where you purchased the product.
* We may apply the auto-stop carbon brush for
improvement in quality without previous notice. Auto-
stop will interrupt current automatically for wear of the
carbon brush. When the disc grinder is stopped for the
built-in auto-stop, check the carbon brush and change it.
How to change
: Remove the brush cap with the
minus driver to take off the carbon brush.
You must purchase the genuine parts in
A/S centers authorized by Würth
company for change. When you use the
carbon brush other than the genuine
parts, the commutator may be worn
rapidly. In result, the life of the tool can
be shortened.
4. Motor
The winding and commutator in the motor are the core
of the disc grinder.
Do not scratch the surface of the winding and
commutator in the motor, and do not apply oil or water
on it.
Dust in the motor causes the trouble of
the motor. After using the disc grinder
for 50hours, let the compressed air in the
ventilation slots in the handle side by
rotating the disc grinder in no-load
revolution to eliminate dust from the
motor.
5. Keep after operation
You must keep the tool out of reach of children in dry
place.
6. Abnormal operation
It is very dangerous for customers to troubieshoot or
repair the tool for themselves. Contact nearby A/S
center (agencies) for solution.
7. X attachment cord
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available
through the service organization.
We declares that these products meet the standards
EN 60745-1, EN 60745-2-3, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3 in compliance with the
directives 2006/42/EC, 20
1
4/
30
/E
U
, 2011/65/EU.
EC Declaration of conformity
D. Assimosis
M. Weiss
General Manager
Executive Vice President
Technical documentation at:
Würth Hellas SA
23rd
Km
Athens-Lamia
National
Road
,
145
68
Krioneri
Attica,
Greece
