1080p IP Streaming Encoder/Decoder
6
4.3 Hardware Setup
Please follow the steps below to complete the system installation:
1) Connect the video/graphics source device to the HDMI input connector on each TX
unit.
2) (Optional) Connect the video display device to the HDMI output connector on each
TX unit.
3) Connect the video display device to the HDMI output connector on each RX unit.
4) (Optional) Connect audio output device (e.g. speaker or headphone) to the audio
output connector of the RX if you want to test additional audio extension.
5) (Optional) Connect RS232 devices as needed if you want to test RS232 serial
extension between TX and RX units.
6) (Optional) Connect compatible IR emitter modules to the IR output connectors of
any TX or RX.
7) (Optional) Connect compatible IR receiver modules to the IR input connectors of
any TX or RX.
8) Connect an Ethernet cable (Cat-6a recommended) from the LAN port each TX and
RX unit to any available LAN port.
9) Connect the control PC to the LAN port of any IPH400E / IPH400D device or to a
Cat-x port of the switch (except the management/console port of the switch).
10) The hardware setup is now complete.
Note:
The default IP mode is DHCP, a network switch which has the function of IP
distributing is needed for setting up the system. Any TX can also be connected directly
to a RX without the switch using CaTx cable to feature point to point extension.
