1080p IP Streaming Encoder/Decoder
8
Upon launch, the IP Streaming Management main window will open up in the “Video
Switching” tab as shown in the picture below:
After starting the IP Streaming Management application, it will show discovered devices
as tiles. There are few things to take note of:
l
The application has many different tabs for controlling the HDMI routing, as well as
routing of other signals such as analog audio, RS232 control, etc. The default
current tab should be "Video Switching", which means the video source displayed
by an RX device (Decoder).
l
The top area of the user interface is labeled "Decoder (RX)". All RX devices
detected on the network will be displayed here.
l
The bottom area of the user interface is labeled “Encoder (TX)". All TX devices
detected on the network will be displayed here.
All connected TX and RX devices on the network will appear as a gray tile within the
application window.
Each tile will identify the “Hostname” of the device. The default device “Hostname” is
the IPH400E/IPH400D. Note that the “Hostname” can be updated at any time by
“Network Setting” interface. The “IP Address” of the device is also shown in the tile.