E-5
CCD Scanners
LI50 Worth Data Long Range CCD Scanner
This CCD Scanner reads typical UPC codes from a .5” to 7” distance. It
acts just like a laser scanner, except the beam is fuzzier than the lasers sharp
line across the bar code. The cable is rated for 1,000,000 bends and is very
durable. The warranty is 2 years.
S10 and S20 Hands Free Laser/CCD Stand
There is a stand available for use with the LZ100 laser as well as the LI50
CCD Scanner. The stand is available as a mountable “goose neck” (S10) or
in a free-standing version with a weighted base (S20). Either stand allows
for hands free scanning of bar codes but is only for use in
Non-Portable
Mode
and requires the TriCoder’s use of the 5 volt power adapter. To use
the stand, simply scan the “Stand on/off” bar code on the base to turn on the
automatic reading mode, then place the scanner in the stand. When a bar
code is placed under the narrow search beam of the scanner, it activates the
full beam and scans the bar code. When you want to use the laser or CCD
as a hand held again, simply scan the bar code on the base again to turn off
automatic scanning. To use the LI50 CCD Scanner with the stand, set the
CCD to “Trigger-less Reading” as described in the settings table defined
below. You must present the bar code within 3-4 inches from the scanner
and use the 5 volt power adapter. Under no circumstances will the stand
work properly while the TriCoder is using battery power.
The drawing below shows an LZ100 Laser Scanner mounted into the S20
weighted-base stand.
