ECRESO FM 5kW / 10kW, user manual
–
11/2021
Page 65
WorldCast Systems SAS - 20 avenue Neil Armstrong - 33700 Mérignac (Bordeaux Métropole) FRANCE
+33 (0)5 57 928 928
–
www.worldcastsystems.com
–
PEAK
(INPUT.MPXn.PEAK)
–
read only
This parameter indicates the peak value of the transmitted signal’s excursion in
kHz.
From -150 to +150 kHz
SAMPLING RATE
(INPUT.LINE1.GET_SAMPLING)
–
read
This parameter reads the sampling rate in Hz.
From 0 to 200000 Hz
5.11.
Player parameters (audio backup)
These parameters are available as:
Front panel
Player menu
see section 6.3.8
Serial commands
INPUT.PLAYER
see section 7.2.6
Embedded web site
Transmitter/Input Source/Audio backup page
see section 8.4.5
They are identical to LINE2 parameters.
5.12.
Audio generator parameters
These parameters are available as:
Front panel
Generator menu
see section 6.3.11
Serial commands
INPUT.AUDIOGEN
see section 7.2.6
Embedded web site
Transmitter/Input Source/Generator page
see section 8.4.5
The audio generator is a multiplex channel and is therefore not affected by the stereo encoder parameters.
STATE
(INPUT.AUDIOGEN.STATE)
–
read/write
With this parameter, set the type of MPX signal generated by the internal generator.
OFF, PILOT, L, R, L+R (mono) or L-R (stereo)
PRE-EMPHASIS
(INPUT.AUDIOGEN.PREAC)
–
read/write
With this parameter, set the pre-emphasis. Select 0 µs is the audio signal is pre-emphasized before getting to the
transmitter. Otherwise, select according to the country: 50 µs in Europe, 75 µs in the USA.
0, 50 or 75 µs
LEVEL
(INPUT.AUDIOGEN.LEVEL)
–
read/write
With this parameter, set the internal generator audio level.
From -100.00 to 12.00 dBFS
FREQUENCY
(INPUT.AUDIOGEN.FREQ)
–
read/write
With this parameter, set the internal generator audio frequency.
From 0 to 100000.00 Hz
