Workzone PT15101201, User Manual

Page: 20 / 32

Use
20
www.coreservice.co.uk
AFTER SALES SUPPORT
20
GB IRE
GB
0190 4727501
IRE
0190 22605
Valve adapter Use
Express valve adapter 11
Bicycle valve (Sclaverand valve, Dunlop valve)
Ball needle 12
Balls
Screw-on valve adapter 4
Screw-on valves (bathing boats, kayaks, pools or
similar)
Conical universal adapter 9
and 10
Air mattresses and similar
Bleed adapter 5
for vent valves (e.g. for a flock bed)
8 mm adapter 6
All valves with an inner diameter
> 8 mm (air mattresses, pools, or similar)
− To open the valve, push the valve cap to-
gether slightly before you insert the adapter.
If you want to inflate products with the enclosed adapters, proceed as follows:
1. Make sure that the On/Off switch 1 is set to the “0” position
(see
Fig. A).
2. Insert the mains plug in a socket.
3. Push the quick-release with lever
19 down.
4. Fit the nozzle adapter 8 on the pneumatic gun 15 .
5. Screw the desired adapter into the nozzle adapter (see the table above).
6. Make sure that all connections are secure.
7. Insert the adapter in the valve.
8. To switch the compressor on, set the On/Off switch to the “1” position.
You can read the work pressure on the manometer 7 .
9. To bleed the air, push the drain valve 16 on the pneumatic gun and check the
pressure on the manometer.
10. Set the On/Off switch to the “0” position as soon as the desired or maximum per-
missible working pressure has been reached.
11. If you no longer wish to use the compressor, pull the mains plug and follow the
steps described in the chapter “Switching the compressor on and off”.
Use as a blow-out gun
You can also use the pneumatic gun as a blow-out gun to clean out cavities or hard-
to-reach areas.
1. Disconnect the pneumatic gun 15 from the compressor as described in the chap-
ter “Disconnecting the pneumatic gun” (see Fig. A).