FORM: PPS SERIES OWNERS MNUL
REV: 05-31-2012
APPR BY: MF
31
Operating the Treadmill
Before switching the treadmill on, the person operating the machine must check that the
emergency solenoid is correctly position. Otherwise the display will not light up. Then
press the ON key. The display now lights up.
To adjust speed or incline, the person operating the machine presses the corresponding
buttons and checks the displays.
The time and distance can be reset to zero by pressing the RESET button.
The person operating the machine can select between various display modes by
pressing the MPH / m/s / km/h button. This does not influence the TIME display.
How to Read the Data Monitor
Introduction:
The data monitor described here indicates the current parameters of the treadmill. The
device has 4 multi-digit displays to indicate the current exercise parameters, as well as
several LEDs to indicate the control mode.
The data monitor displays the following values:
Speed of the treadmill in meters per second or kilometers per hour.
Adjusted incline of the treadmill in percent.
The distance run in meters since the belt was last started.
The energy burnt in calories.
The exercising time.
The current pulse rate (if the treadmill is fitted with a pulse receiver).
The control mode of the treadmill (remote control/manual operation/stop mode)
The LEDs to the right of the displays indicate the unit of the displayed value, or to
distinguish between various parameters presented on the same display.
The data monitor is only a display unit with limited facilities to control the treadmill.
Summary of Contents for PPS 43
Page 26: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 26 PPS Med 43 PPS Med 55 PPS Med 70...
Page 48: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 48 WARRANTY INFORMATION Chapter 6...
Page 55: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 55 966 3929 800 WOODWAY...
