FORM: PPS SERIES OWNERS MNUL
REV: 05-31-2012
APPR BY: MF
43
Outer Covering
Removal:
Disconnect the treadmill from the mains and remove the two (2) large screws in the
outer covering using a cross-recess screwdriver. The covers can then be lifted up from
the frame of the treadmill.
Replacement:
Position the two outer coverings on both sides of the frame. Then tighten the large
screws. It is important to check whether the treadmill scrapes on the covering panels by
moving the mat backwards and forwards. If this is in fact the case, the screws must be
loosened again and the covers moved away from the mat.
Manual Display
Required tools:
cross-recess wrench / 10 mm / 10 mm ring forked wrench.
Removal:
1. Unscrew the fastening screws on the back of the plastic housing until the front
section can be removed.
2. Lift the entire unit out of the housing.
3. Disconnect the BUS cable by pulling the plug only (never pull the cable).
Replacement:
1. Connect the cable and plug again.
2. Then carefully insert the complete display from above, taking care not to crush
the cables.
3. Insert the small screws through the back of the housing.
4. Switch on the power supply and check that the treadmill works properly.
Drive Motor and Pulley
The instructions are supplied with the new or replacement motor, pulley is included.
Summary of Contents for PPS 43
Page 26: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 26 PPS Med 43 PPS Med 55 PPS Med 70...
Page 48: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 48 WARRANTY INFORMATION Chapter 6...
Page 55: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 55 966 3929 800 WOODWAY...
