FORM: PPS SERIES OWNERS MNUL
REV: 05-31-2012
APPR BY: MF
52
4. Erratic or Blinking Display
Probable causes: Low line voltage; too much load on the same line.
Make sure treadmill is on a dedicated electrical circuit.
Possible static problem / spray with staticide.
Display power supply on Interface board is defective.
5. Squeaking Sounds:
Possible causes:
Noisy bearing(s). Try greasing or replacing the bearing.
Drive belt rubbing against the drive pulley, try greasing the edge of the drive belt
with a little all purpose grease.
Running belt rubbing against drive pulleys, try lightly greasing the teeth on the
drive shaft, and let the treadmill run at a slow speed for a couple of minutes to
spread grease evenly. (NOTE: Too much grease will make a mess and will
accumulate dust.)
Check for a defective guide roller or Z roller bearing on the bearing rail, replace if
defective
Summary of Contents for PPS 43
Page 26: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 26 PPS Med 43 PPS Med 55 PPS Med 70...
Page 48: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 48 WARRANTY INFORMATION Chapter 6...
Page 55: ...FORM PPS SERIES OWNERS MNUL REV 05 31 2012 APPR BY MF 55 966 3929 800 WOODWAY...
