Woods RC3.5E, Operator'S Manual

Page: 20 / 57

20 Assembly
MAN1253 (3/15/2018)
Figure 27
. Cutter Assembly
1.
Attach Tailwheel Bracket (9) and Lift Arms (4) to cutter rail using 1/2 NC x
2 cap screws (17) and 1/2 NC flange lock nuts (19).
2.
Select desired height adjustment holes and secure Tailwheel Bracket (9)
with 1/2 NC x 1-1/2 cap screws (18) and 1/2 NC flange lock nuts (19).
3.
Rotate A-Frame Bars (1) up and attach Break Links (3), Sleeve (2) to
lower hole in top of A-Frame Bars (1) using 3/4 NC x 5-1/2 cap screw
(13) and 3/4 NC lock nut (14).
4.
Rotate Lift Arms (4) upward and attach to Break Links (3) using Sleeves
(5), 5/8 NC x 2-1/2 cap screws (15), and 5/8 NC flange lock nuts (16).
See
Attaching Cutter to Tractor, pg. 10 for adjustments.
5.
Attach Rubber Belting (8) and Belting Bar (10) to front of cutter using 3/8
NC x 1-1/4 carriage bolts (11) and 3/8 NC flange lock nuts (12). (Omit if
installing optional chain shielding).
6.
Secure Tailwheel (7) to Tailwheel Bracket (9) using 33 mm washer (6)
and spirol pin (20).
INSTALL DRIVELINE
(FIGURE 28)
Select either the standard shear bolt or optional slip clutch driveline.
Figure 28
.
Shear Bolt and Slip Clutch Assembly
1. A-Frame bar
2. 19.1 x 31.8 x 76.2 mm (.75"
x 1.25" x 3.0 ")Sleeve
3. Break link
4. Lift arm
5. 15.9 x 25.4 x 32.0 mm (.626"
x 1.00" x 1.26") Sleeve
6. .33 mm Flat washer
7. Tailwheel
8. Rubber belting
9. Tailwheel bracket
10. Belting bar
11. 3/8 NC x 1-1/4 Carriage bolt
12. 3/8 NC Flange lock nut
13. 3/4 NC x 5-1/2 Cap screw
14. 3/4 NC Lock nut
15. 5/8 NC x 2-1/2 Cap screw
16. 5/8 NC Flange lock nut
17. 1/2 NC x 2 Cap screw
18. 1/2 NC x 1-1/2 Cap screw
19. 1/2 NC Flange lock nut
20. Spirol pin
1. Clutch shield
2. 5/16 NC x 3/4 Cap screw
3. 5/16 Lock washer
4. 5/16 Flat washer
5. Retaining ring
6. Shear bolt driveline
7. 1/2 NC x 3 Cap screw GR2
8. 1/2 NC Lock nut
9. Slip clutch driveline
10. 1/2 NC x 3 Cap screw GR8