Wood-mizer SHR-T Series, User Manual

Page: 64 / 110

Clamp Roller Alignment
4
4-20 MHdoc051512
4.12 Clamp Roller Alignment
Clamp Roller Arm Tilt
Check that for the first and the third clamping rollers the end closest to the infeed table is
5 mm (±1mm) from the top surface of the feed track chain (see the figure below). If the
distance is different, adjust the tilt of the roller arm using the adjustment screws in the
clamp roller guide.
See Figure 4-18. Release the clamp. Loosen locking nuts on the adjustment screws
located in the clamp roller guide. Use appropriate adjustment screws to adjust the clamp
roller arm.
FIG. 4-18
5mm 1mm ±
Realese
the Clamp
Loosen side lock
nuts and adjusting
screws (8)
Loosen locking nuts on adjustment screws
and use appropriate adjustment screws
to adjust clamp roller arm
rs_029
Loosen locking nuts on adjustment screws
and use appropriate adjustment screws
to adjust clamp roller arm