Wood-mizer SHR-T Series, User Manual

Page: 29 / 110

Obs³uga maszyny
Machine Start
Obs³uga maszyny MHdoc051512 2-10
2
See Figure 2-7. The speed at which the feed track moves is adjustable. The feed track
speed switch, located on the control panel, allows the operator to adjust the feed rate
from 0 to ca. 30 m per minute.
Turn the switch clockwise to increase the feed rate, counterclockwise to slow the feed
rate down.
Factors that will determine what feed rate you can use include:
„
Width of material to be cut. Eight-inch material will require a slower feed rate than 1"
material.
„
Hardness of material to be cut. Some woods that are seasoned or naturally very
hard will require slower feed rates.
„
Sharpness of blades. Dull or improperly sharpened blades will require slower feed
rates than sharp and properly maintained blades.
„
Off-bearing capability. Your ability to feed end-to-end will also determine what feed
rate you can use.
FIG. 2-7
EMERGENCY
STOP
“0”
I
II
START
STOP
STOP