Wood-mizer SHR-T Series, User Manual

Page: 52 / 110

Blade Wheel Alignment
4
4-8 MHdoc051512
9. Check the position of the blade on the drive-side blade wheel. The blade should be
positioned on the wheel as described for the idle-side blade wheel. Adjust the drive-side
blade wheel if necessary.
See Figure 4-8. Use the horizontal adjustment screws (marked with the blue and yellow
arrows in the figure below) to adjust the drive-side blade wheel. Before adjusting the
wheel, loosen the drive belt using the adjustment bolts marked with the orange arrows in
the figure.
To move the blade back on the wheel, loosen the right adjustment screw one quarter turn.
Loosen the jam nut on the left adjustment screw and tighten the screw. Tighten the left
and right jam nuts.
To move the blade out on the wheel, loosen the left adjustment screw one quarter turn.
Loosen the jam nut on the right adjustment screw and tighten the screw. Tighten the left
and right jam nuts. When the adjustment is complete, tension the drive belt properly (
See
Section 3.8 ).
FIG. 4-8
rs_022