Wood-mizer SHR-T Series, User Manual

Page: 54 / 110

Blade Guide Arm Vertical Adjustment
4
4-10 MHdoc051512
4.5 Blade Guide Arm Vertical Adjustment
1. Adjust the blade guide arm out to within 1/2" (15 mm) of full open.
2. Measure the distance from the top surface of the feed track to the arm.
See Figure 4-10.
3. Adjust the blade guide arm in to within 1/2" (15 mm) of full closed. Measure again the
distance between the arm and the feed track.
4. Adjust the arm so that the measurement from the top of the track feed to the arm in the
closed position is the same as the measurement from the top of the track feed to the arm
in the open position.
If the arm is too low in the closed position, loosen the lower outside roller and tighten the
upper outside roller. (See Step 5.)
If the arm is too high in the closed position, loosen the upper outside roller and tighten the
lower outside roller. (See Step 5.)
5. The rollers are mounted on cam bolts that raise or lower the arm when turned.
To adjust the rollers, locate the cam bolt inside the housing and turn until the arm is
lowered or raised as needed. Recheck the arm in both the open and closed positions.
FIG. 4-10
Turn outside rollers
to raise or lower end
of blade guide arm
20_038