Sawmill Operation
Restore Factory Defaults
Sawmill Operation
WMdoc072919
4-17
4
NOTE:
This menu provides diagnostic information regarding voltage,
current and software revisions. This information can be useful for trou-
bleshooting by a qualified Wood-Mizer service representative.
Restore Factory Defaults
1.
If on, turn the key switch to Off (0).
2.
Turn the key switch On (1) while pressing and holding the Toggle button.
All Accuset settings are returned to their factory default values, including:
Calibration settings.
to recalibrate the Accuset control.
PID values.
See PID (Proportional - Integral - Differential) Values
4.7
Accuset Mode Selection
To select an Accuset mode, press the desired Mode Select button (Auto-Down, Auto-Up
or Pattern) located under the display. Press the Manual Mode Select button to return the
control to Manual Mode.
Manual Mode
- This mode allows you to use the up/down func-
tion of the sawmill as you normally would without the Accuset option. The Current Blade
Height will continue to be displayed by the Accuset control.
Auto-Down Mode
- This mode
references the current blade height
and allows you to
choose an increment to move the blade
down
. The Accuset will automatically move the
saw head down and stop at the next increment when you press the drum switch down.
You can store sixteen different increment levels using the four numbered Increment Set-
tings buttons. Each button stores four adjustable increment settings. Press button #1
once for setting #1. Press button #1 a second time for setting #5, etc...
Auto-Up Mode
- This mode
references the current blade height
and allows you to choose
an increment to move the blade
up
. The Accuset will automatically move the saw head up
and stop at the next increment when you press the drum switch up. Auto-Up mode is pri-
marily used to raise the saw head in large increments when preparing to cut a new log or
log that has been turned. This allows the operator to raise the saw head without having to
hold the drum switch up, freeing the operator to perform other functions while the saw
head is being raised. The Increment Settings buttons work in the same manner as
described in Auto-Down Mode.
NOTE:
The sixteen increment settings apply to Auto-Down AND
Auto-Up modes. If you change a setting in Auto-Down mode, it will also
change when you are in Auto-Up mode.
Pattern Mode
- This mode
references the bed surface
and allows you to program up to
six different increments calculated up from the bed. The sixth (top) increment repeats
