Sawmill Setup
Tensioning The Blade
Sawmill Setup
WMdoc072919
3-34
3
3.3
Tensioning The Blade
See Figure 3-15.
Tension the blade by turning the hydraulic tensioning handle clockwise
until the tension gauge indicates the recommended tension.
See Table 3-1.
The recommended tension for different blades is shown below.
The tension gauge should be checked occasionally when adjusting the cant control or
while cutting. Ambient temperature changes will cause tension to change. Adjust the ten-
sion handle as necessary to maintain the recommended tension level.
CAUTION!
Changes in temperature could cause changes in pressure
in the blade tensioner, and loss of fluid from the gauge may result.
Release the blade tension when the mill is not in use to avoid damage
to the tensioner.
3.4
Tracking The Blade
1.
Ensure that the blade housing cover is closed and all persons are clear of the open side
of the saw head.
2.
Start the engine.
FIG. 3-15
Blade Type
Acceptable Range
All Blades
2800 - 3000 psi
TABLE 3-1
LX0009-01
Blade Tensioner Gauge
Blade Tensioner Handle
Cant Control
