Troubleshooting Guide
Power Feed Problems
Troubleshooting Guide
WMdoc072919
6-4
6
blade guide, accessory, ignition, and start breakers are located inside the control box.
Remove the circuit breaker panel to access the internal breakers.
NOTE:
If the breaker is hot, it may not reset immediately. Allow the
breaker to cool before attempting to reset.
6.4
Power Feed Problems
WARNING!
Before performing service near moving parts such as
blades, pulleys, motors, belts and chains, first turn the key switch to
the OFF (0) position and remove the key. Failure to follow this could
result in death or serious injury.
WARNING!
Disconnect the negative battery terminal cable
. Failure
to follow this could result in death or serious injury.
Test to determine if the problem is mechanical or electrical.
1.
Remove the drive belt from the power feed drive pulley.
2.
Reconnect the negative battery terminal.
3.
Turn the key switch to the ACC position.
FIG. 6-1
LX0023
Autoclutch
Engage Sensor
Control Box Rear
Power Feed
Circuit Breaker
Internal Circuit Breakers (Remove Panel)
Blade
Guide
Accessory
Ignition
Not
Used
Start
Up/down
Circuit Breaker