Maintenance & Alignment
Replacing the Blades
5
5-1
EGdoc031621
Maintenance & Alignment
SECTION 5 MAINTENANCE & ALIGNMENT
WARNING!
Before performing service near moving parts such as
blades, pulleys, motors, belts and chains, set the main switch in the "0"
position and disconnect the power cord.
WARNING!
Always shut off the motor and allow all moving parts to
come to a complete stop before removing any guards or covers.
Do NOT operate with any guards or covers removed.
WARNING!
Visible and/or invisible laser radiation. Avoid eye or skin
exposure to direct or scattered radiation.
DANGER!
The operator must not for any reason perform any service
or repairs to the laser sight.
WARNING!
Do not replace the factory-installed laser sight with any
different laser sight, or mount any additional laser devices.
5.1 Replacing the Blades
Replace the blades as necessary. Dull blades will cause the motors to work harder and will result in
decreased cut quality and accuracy. Blade life will vary depending on maintenance of the machine, the
operator ase well as species and condition of wood being sawn.
DANGER!
Before changing the blades, make sure the blade mounting
arbors have come to a complete stop and the motor is shut off
completely. Turn the main switch to the "0" position and disconnect the
power cord. Failing to do so can cause serious injury.
WARNING!
Always wear eye, glove and foot protection when handling
the blades.
1.
Move the blades all the way out (to the maximum cutting width).
See Figure 5-1
2.
Turn off the blade motors and wait until the solenoid interlock (A) is inactive. Then set the main switch
in the "0" position and disconnect the power cord.
