Wood-mizer EE20S-EMR, User Manual

Page: 69 / 159

Maintenance & Alignment
Alignment
Maintenance & Alignment EGdoc022715 6-10
6
3. Place a 60mm wide bar along the outside edge of the blade and so that the bar is aligned with the 0
mark on the scale and the bar meets the fence.
See Figure 6-7.
4. Tighten the blade clamps and check the alignment again.
5. Check if the fixed blade laser indicates the left edge of the bar. If not, loosen the laser mounting bolts
and slide the laser as necessary. Next, tighten the mounting bolts.
See Figure 6-7.
Adjustable blade and its laser indicator alignment
6. To position the adjustable blade, set the blade to 200mm (7.874") using buttons or and
scale (EG300) or turn the setworks handle as necessary, and release the pin into the appropriate
labeled hole (EG250). Measure from the inside of the fixed blade to the inside of the movable blade.
If necessary, loosen the movable blade arm and slide the blade assembly on the shaft until the
blades are 200mm (7.874") apart. Retighten the blade arm. If the adjustable blade has been aligned,
it is necessary to perform the auto-calibration procedure and enter the real blade width to Setwork
FIG. 6-7
60mm
Laser
Laser Beam