Wood-mizer EE20S-EMR, User Manual, Page: 57 / 159

Setworks Operation (EG300 U.S. Only)
Setworks (Optional - U.S. Version)
Setworks Operation (EG300 U.S. Only) EG 99 doc022715 5-4
5
5.1.6 Calibrate Blades Position
After the Setworks option is installed or if inaccurate position of the blades is observed, calibration of
the Setworks control with the saw head position may be required.
Adjust the blade positions so the blades are an easy-to-measure distance from each other. NOTE:
Because the Setworks control calibration values are limited to integers between 0 and 9, the
distance between the blades should be set less than 9.999 inches in Imperial units or 999.9mm in
Metric units. When adjusting the head positions, be sure to move the heads in past the target
position and then out to compensate for any backlash in the mechanical syste.
See Figure 5-7. Push the left arrow labeled ‘Cfg.’ to enter the Configuration menu. Push the F4
button to enter the Calibration menu. If using Imperial Fractions or Imperial Decimal units, the
Calibration menu will display in inch increments. If using Metric units, the menu will display
increments in millimeters.
Use the F1 - F4 buttons to scroll each value as desired. When the value reaches ‘9’ pushing the
button again will return the value to ‘0’. Adjust the values until the Calibration Position equals the
actual measurement between the blades.
To save the Calibration Position setting, push the right arrow button labeled ‘CAL.’ To exit without
changing the calibration, push the left ‘BACK’ arrow. Push the Back button to return to the
Configuration screen or the ‘ESC’ button to return to the Main screen.
FIG. 5-7
ESC ENTER
F1 F2 F3 F4
TVS017
0 - 1
/ 2
1 - 0
/ 0
1 - 1
/ 4
1 - 1
/ 2
Push left arrow labeled ‘Cfg.’
ESC ENTER
F1 F2 F3 F4
IMP.
FRCT
IMP.
DEC. MET CAL.
OFF ON OFF
Push ‘F4’ to enter Calibration Menu
ESC ENTER
F1 F2 F3 F4
1.0
ESC ENTER
F1 F2 F3 F4
.1 .01 .001 100 10 1 0.1
Imperial Calibration Menu Metric Calibration Menu