WOLFF EF 135, Translation Of The Original Instructions

Page: 21 / 36

21
4.2 Depth adjustment Cutting depth Figure D
The depth can be adjusted from 0 to 35 mm.
► Loosen the wing nut ( 8 ) of the depth stop.
► Set the desired depth by moving the depth stop ( 9 )
and retighten the wing nut ( 8 ).
► Before starting work, check the depth setting on a test
piece.
► Check the cutting blades before use.
They must be properly mounted and free to rotate.
Perform a test run of at least 1 minute without load.
Do not use damaged, non-circular or vibrating cutting
blades. Damaged saw blades burst and can cause
injury. .
4.3 Working Advice
► Do not strain the machine so heavily that it comes
to a standstill.
► The machine may only be used for dry cutting.
– Adjust the cutting depth, see section “Pre-selectingthe
Cutting Depth”.
– Guide the machine with both handles, applyingmodera-
te feed, suited to the material being worked.
– The machine must always work in an upward grinding
motion. Otherwise, the danger exists of it being pushed
uncontrolled out of the cut.
– After fi nishing the working procedure, swivel the cutting
unit out of the slot with the machine still running, until
the cutting unit engages in the uppermost position.
– Switch the power tool off .
Do not brake coasting cutting blades by applying pres
sure to the side.
► Cutting blades become very hot during
operation; do not touch them until they have co-
oled down.
WARNING!
NOTE
Warning
4.4 Inserting/changing the battery Figure F+G
► Charged battery until fully charged
Push the catch into the power tool
► To remove the unlocking buttons
Press (1.) and pull out the battery (2.).
CAUTION!
When not in use, disconnect the contacts of the battery
protect. Loose metal parts can short-circuit the contacts,
there is a risk of explosion and fi re!
4.5 Battery charge status Figure H
► By pressing the button, the battery status LED can be
used to check the battery charge status.
► The display goes out after 5 seconds.
If one of the LEDs fl ashes, the battery must be char-
ged. If no LED lights up after pressing the
button, the battery is defective and must be replaced.
4.6 Using rechargeable batteries
► Only use original batteries with the capacity indicated on
the type plate of your power tool.
Voltage. If other batteries are used, e.g. imitations, re
conditioned batteries or batteries from other manufactu
rers, there is a risk of injury and damage to property.
damage caused by exploding batteries.
► Only charge the batteries with chargers recommended
by the manufacturer. Using a charger suitable for a
specifi c type of battery, there is a risk of fi re if it is used
with other batteries is used.
► The battery can be damaged by pointed objects such
as nails or screwdrivers or by external force. This can
lead to an internal Short circuit and the battery may burn,
smoke, exploden or overheat.
► For marking the power tool only use adhesive labels. No
holes into the housing.
► Spindle lock only when stationary
Press grinding tool.
4.7 Clean the dust fi lter regularly Figure I
► Remove the dust fi lter and clean it with dry
Blow out compressed air.
EN