EN
W415-2968 / B / 04.30.21
3
general information
1.0 general information
!
WARNING
•
The Ducted Heat Management (DHM) kit MUST
be installed during the framing of the appliance
BEFORE
gas is
installed.
•
All wiring should be done by a qualifi ed electrician and shall be in compliance with local codes. In the absence of local codes,
use the current CSA22.1 Canadian Electric Code in Canada or the current National Electric Code ANSI/NFPA NO. 70 in the
United States.
•
Installation must conform to local codes or, in the absence of local codes, the National Gas and Propane Installation Code
CSA B149.1 in Canada, or the National Fuel Gas Code ANSI Z223.1 / NFPA 54 in the United States.
•
To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs, beds, carriages,
or play pens. This bag is not a toy. Knot before throwing away.
•
Ensure the appliance is completely cool before starting installation.
Ducted Heat Management (DHM)
is a system for managing the heat produced by the appliance at and around the
fi replace. The purpose of the
DHM
system is to move the heat away from the fi replace to allow it to circulate more
effectively within the living space. By installing
DHM
both the installer and the user gain considerable benefi ts, see the
following;
Installer:
•
Ability to use combustible framing and fi nishing right up to the fi replace opening.
*
•
High temperatures above the front of the fi replace opening are signifi cantly reduced eliminating potential degrading
to sensitive fi nish material (cracks or discoloration).
•
No additional electrical or fans are required which keeps installation straightforward.
User:
•
Heat is circulated more consistently throughout the living space increasing comfort in front of the fi replace.
•
Increased “real world” effi ciency as heat is moved into the room rather than retained inside the enclosure.
•
Complete fl exibility in selection of fi nish materials.
•
Ability to place a TV, sound bar or artwork above the fi replace.
**
The
DHM
system relies on an optimized fl ow of air both through the appliance and the enclosure. As such the
installation of the
DHM
system requires certain technical considerations when compared to traditional fi replaces.
Specifi cally, the
DHM
system requires the
enclosure to be ventilated
and requires the installer to ensure that a
minimum air outlet opening area is provided to allow heat to escape and circulate at a prescribed minimum height and
position. This
must
be carefully adhered to in the planning and the installation to ensure the appliance functions safely
and to minimize installation time.
*
In most common installation confi gurations, some specifi c installations require special provisions.
See “minimum clearance to combustible enclosures” section for details. Ensure to strictly adhere to
instructions.
**
Always check appliance manufacturers’ recommendations to confi rm suitability and any special
environmental limitations. For valuable or antique items, always refer to expert preservation instructions as
some items require specifi cally controlled temperature and/or humidity.
DUCTED HEAT MANAGEMENT
