W415-2968 / B / 04.30.21
EN
12
appliance pre-installation
1.) Remove fasteners securing front frame (and rear
frame for see-thru).
Do not discard fasteners.
Before starting the DHM installation, remove the safety barrier. Refer to “safety barrier installation/removal” section
in the appliance installation manual.
SINGLE-SIDED MODEL ILLUSTRATED
SINGLE-SIDED MODEL ILLUSTRATED
2.) Remove knockouts plates. Discard knockout plates.
Recommended: Use a fl athead screwdriver or a small pry
bar and use prying motion to remove the knockout
. Use
a brace such as a piece of wood under the prying tool to avoid
distorting the top
3.) Remove the fasteners securing the cover plates recessed below the knockout plates. For ease of removal, lift
the panel from below in front of the fi rebox door. Discard cover plates.
access side
access side
COVER PLATE
IMPORTANT:
Fire Hazard Warning: This step is crucial for your appliance to work properly. If the
knockout plates AND the cover plates are not removed, the appliance will overheat,
the barrier will become excessively hot, and the high limit switch will constantly trip.
Front Frame
Cover Plate
!
WARNING
•
Both sets of knockouts
MUST
be removed when using
DHM
.
•
FOR LVX MODELS ONLY:
The top defl ectors
MUST
be removed when using
DHM
.
4.0 appliance pre-installation
4.1
knockout plate removal
Move appliance into place.
note:
