W415-2968 / B / 04.30.21
EN
10
rough framing
1. Slide the manifold into the back of the sleeve (step A) until the slots engage the top tab in the sleeve (step B)
(see above).
Some components and framing
hidden for clarity.
MANIFOLD
SLEEVE
2. For front discharge: Install 2 screws through the holes along the front and 1 screw along the side of the
manifolds (see below).
3. For side discharge: Install 4 screws through the holes along the front of the manifold (see below). Repeat on
opposite side.
Front discharge
Side discharge
There are optional securing holes along the bottom of the sleeve.
note:
There are 4 optional securing holes along the sides and bottom of the sleeve.
note:
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
Type 1
3.2 manifold
installation
SLOT
TOP TAB
When installing the manifolds for front discharge, the manifolds
must
be installed at both ends of the sleeve leaving the middle section open.
note:
