Bedienungsanleitung Steuerung S4_2006_09_25-neu.doc
Page 65 / 83
© wodtke GmbH Tübingen. All rights reserved. Subject to change without notice.
Month of issue xx/2007
Art. No. 950 281
6. Using a cleaning brush, clean vertical right-
hand flueway along its entire length.
Be sure also to clean the horizontal
connecting hole (1) on the right leading
through to the firebox.
7.
Open the firedoor, take out the grate and
vacuum burner pot. Lift burner pot out and
clean. Clean combustion air holes with a
suitable
implement
(screwdriver)
if
necessary.
[An
dieser
Stelle
ist
im
Deutschen ein Fehler – Anm. d. Ü. XX]
8. Vacuum firebox, pot holder and base plate
thoroughly.
Important notes: When inserting the burner
pot again make sure it rests fully on the pot
holder. Remove any combustion residues on
the pot or pot holder. Check that the burner
pot is firmly seated in the pot holder and
doesn’t side-wobble by more than 1 to 2 mm
– if it does, you will need to replace the
burner pot (wearing part). The “burner nose”
must point forward.
9. Release both screws on inlet grille and
remove grille.
