installation & connection
18_
installation & connection
Outdoor installation
When you install it outside of the building, please waterproof it with waterproof butyl rubber tape (can be
purchased in stores) so that water does not leak from the gap of the cable connected to the outside.
1.
Connect the power, I/O, and network cables.
2.
Wrap the black cable jacket (Area A) and the cable connection area
with waterproof (butyl rubber) tape so that more than half of the
butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause
leakage. Make sure to protect the cable with a dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to twice its normal length.
Adjusting the monitoring direction for the camera
Tilt
Pan
`
Adjusting the monitoring direction
You can adjust the camera direction only when the camera is fixed on the ceiling.
At this time, rotating the main body of the camera in the left and right direction is called PAN, and adjusting
the angle of the camera is called TILT.
- The effective range of pan is a total of 355 degrees.
- The effective range of tilt is a total of 60 degrees.
J
`
The image can be covered up by the camera case depending on the angle.
`
Methods of adjustment
1.
After installing the camera, adjust the panning angle in consideration of the monitoring direction.
2.
Adjust the tilt angle so that the camera faces toward the monitoring object.
Summary of Contents for PNM-9031RV
Page 1: ...NETWORK CAMERA User Manual PNM 9031RV ...
Page 32: ......
